Office Data Star 115 Brandsikret Dataskab (228 LTO) - Indbrudstest Grade S2 / Brandtest 60 min - Nøglelås

De beløb, der kan sikres i et bestemt pengeskabe variant på tværs af europæiske lande. Pengeskabe skal certificeres i henhold til EN-1143-1 eller EN 14450-forskrifterne. Disse veldefinerede standarder klassificerer pengeskabe i sikkerhedsgrader. - Som ses i tabellen under artiklen.

Find below the most Frequently Asked Questions regarding security, battery and other concerns of Safe Locks.

SafeGear offers you a wide variety of delivery options. We find the best delivery partners and ensure fast and safe delivery. To our services belongs delivery with or without installation and standard or express delivery. The following guideline will give answers to all questions you may have.

Be aware that there are no wiring or piping in the location you want to install the safe.  

Follow these steps to bolt your safe:

You can easily bolt your safe following 8 simple steps.

	1. Place the safe onto its final position.
	2. Mark the spot on the floor or the wall where the bolting holes are located.
	3. Move the safe aside.
	4. Make sure you use the right drill for the material and an appropriately sized drill bit.
	5. Drill holes into the designated marks.
	6. Reposition the safe over the mounting hole.
	7. Insert the bolt through the inside of the safe into the hole.
	8. Tighten up the nut of the bolt.

Before buying a fireproof safe, you need to consider that the sensitivity to heat varies throughout material. So you should know the material of the valuables you want to keep protected from fire damage. Usually, it is distinguished between documents (business reports, licenses, birth certificates, old artifacts, passports, insurance documents etc.) made of paper, and data (hard drives, CDs & DVDs, old negatives & photographs, flash drives, old cassette tapes, USB drives, micro SD cards, etc.). Thus, different fire resistance standards are required:

Fireproof Safes for Paper Documents

When exposed to fire, the interior temperature in the closed safe should not increase by more than 150°C because this would harm the documents. As an insulation material, a special mixture of cement/mortar and water is usually used. The relatively high amount of bound water in the mixture keeps the temperature in the wall of the safe at a maximum of around 100°C.

Fireproof Data Safes

Data is damaged at lower degrees. So when exposed to fire, the interior temperature in the closed data safe should not increase by more than 30-50°C. The walls of the safe are usually constructed in several layers. In the first layer, a special mixture of cement/mortar and water is used. There the temperature does not increase to more than 100°C. In the middle layer, special insulation materials are used, which prevent the heat from getting through the wall. As third layer, heat-absorbing material is used, which has a cooling effect on the wall.

Depending on the requirements of the fire resistance class, different filling materials or wall thicknesses are used.

Common to both types: Sealings are installed in the gaps of the door. Depending on the fire class requirements, high-temperature-resistant seals against fire gases or penetrating heat are utilized. These modern seals swell from a certain temperature and reliably close the door gap in the event of a fire.